The start switch might be defective if the dryer does not respond or makes any. If the dryer hums but does not start, the start switch is not at fault.
If the door stays ajar or some item prevents the door from staying closed, the dryer will not start.
Roper gas dryer won't start. If the switch does not have continuity, replace it. The start switch is not faulty if the dryer hums but does not start. Also, check that the appliance is plugged in and that the gas supply valve is ‘on.’ roper dryer timer not working
If your dryer is not starting, see if the start switch is broken. If your roper dryer won’t start, you first want to ensure that power is coming to the appliance. My roper clothes dryer won't start some possible reasons are:
If the dryer does not respond or make any noise, the start switch could be at fault. Or 4) circuit breaker has been tripped at your control panel. 1) door switch is bad, 2) overheat thermostat or fuse inside machine has been tripped, or 3) controller/timer has failed.
If you learn them carefully, we assure you that you will fix your roper dryer quickly. As it is humming, try to rotate the drum. Dec 8, 2016 #1 model number rel4434aw0 brand roper age more than 10 years dryer stopped mid cycle won't start again.
To determine if the start switch is defective, attempt to start the dryer. 5 no voltage at wall. Most common reason for no run is 1 thermo fuse, 2 door switch, 3 motor, 4 timer.
If it does start to turn, you definitely need to replace the motor. Gas dryer 120 volts, 6 push to start relay Haven't really checked anything as of yet being as old as what it is before i wasted time tearing it apart figured.
Open the door and tape the door switch closed. Use a multimeter to test the start switch for continuity. As said no belt switch on your's.
There might be a start switch or control panel issue. Examine the dryer's panel door to verify it is closed firmly. Check the breaker box that goes to the area your dryer is loaded and flip on any breakers that have tripped.
Make sure the hum you hear is. Put it into any cycle and press the start button.